Meepo Shuffle V4 Dual 620W Hub Motor Kit - Used Replacement Part

This listing is for a Meepo Shuffle V4 dual 620W hub motor kit, suitable as a replacement or spare part for your electric skateboard setup. The item is in used condition, so expect normal signs of prior use; check the listing for details on what is included and current cosmetic/working status. It is priced at $62.00 USD and ships with free shipping. Review the photos and description carefully to confirm compatibility with your board and to verify all included components before purchase.

Before you buy

• Ungraded cards can vary—zoom in on photos for surface, corners, and centering.
• If it’s a “pick your card/insert” listing, confirm the exact card name/number in the listing.
• Review shipping rules (combined shipping / envelope vs mailer) on the listing.

The Meepo Shuffle V4 dual 620w hub motor Kit is a high-performance electric skateboard setup that offers dual hub motors powered at 620w each. This kit is designed to enhance the speed and agility of the skateboard, allowing riders to achieve greater distances and perform tricks with ease. With the trusted Meepo brand behind it, this kit is sure to provide a reliable and powerful performance for electric skateboard enthusiasts.These are from boards I purchased without batteries, and then disassembled for my own purposes. I’m parting out the rest: these have never been ridden, and 100% work. These ones do not have the original meepo esc connectors and motor phase wire connectors, and instead the wires were cut short - if you need those, see my other listings as I have a few of these with the factory harnesses for a bit more money. The last image in the listing shows the wires you’ll find inside the cut sheathing - three phase wires for the motor, and 5 hall sensor wires (no temp sense on these motors). This listing includes the Shredder truck and two hub motors without the factory v4 shuffle wiring harness connectors for the hall sensors and the phase wires. 100a durometer meepo bushings installed, I can vouch for the fact that these motor sets go fast and hard, and you should have no problem getting close to 30mph or faster with the right controller.Final note, feel free to contact me if you need custom wire connectors installed on these to suit a custom build or some other brand, most factory hub motors controllers will work just fine with these, but belt drive motors typically won’t since they have different output curves and logic. Message me for info if you like. I can put whatever connectors you need on them for an additional fee, I’ve wired things like this my whole life and I’ll happily do that for the cost of the connectors plus 10 bucks for soldering, wiring, and heat shrinking them before shipment, but it will cause a delay in shipping out unless I have the type of connector you need laying around. Contact me with any questions.